I just failed emissions and went to check my O2 sensor and EGR, the O2 seems to be fine. Then I was going to clean my EGR, but before I disconnected it, I noticed the hose is not there, I think this might be the cause of my problem. This is on an H22A if that matters.
My question is where am I supposed to connect this to? The part coming out on the right side is what I'm talking about.
Also my idle is low and the car does die after hard acceleration so it definately seems like this should be the issue, however if this does not bring my idle up enough, if someone could show me which screw I turn on the throttle body to adjust the idle I'd appreciate that.
Thanks in advance for your help.
My question is where am I supposed to connect this to? The part coming out on the right side is what I'm talking about.
Also my idle is low and the car does die after hard acceleration so it definately seems like this should be the issue, however if this does not bring my idle up enough, if someone could show me which screw I turn on the throttle body to adjust the idle I'd appreciate that.
Thanks in advance for your help.
Comment