Originally posted by xkjnboix
View Post
Announcement
Collapse
No announcement yet.
SUSP: Front Sway Endlink replacement
Collapse
X
-
Originally posted by Juan4DCB7 View Postdid this install a while back and it is one of those mods that you can actually feel the difference with. I donno if it really helps you much except for ride quality, but bushings are a good upgrade.
Also, I don't see any reason to replace with OEM, but upgrade to poly as they will last longer. OEMs will eventually dry rot and break apart.
I agree with only tightening the endlinks by hand until you can not rotate any of the washers inbetween. Another tip is to lubricate the entire length of the long thru-bolt with anti-seize so that you can take these apart in the future. Over time in corrosive environments the spacers, thru-bolt and washers seize to one another and need to be cut off.Last edited by HondaFan81; 08-05-2009, 10:53 AM.
Comment
-
Originally posted by JDMcb792 View PostI have this problem with front sway bushing end. Mine was all tear up in pieces after I lower my car it was making werid noises everytime I turn left & drive. How much does it cost? at autozone.
u should spend 15-20 $ autozone just for the front left and right endlinks. this covered thoroughly throughout the thread
Comment
-
Originally posted by sleepygreen View Postif u guys have an O'Rielly's near by they sell a poly bushing kit for ten bucks... i did it to mine and steering response is way better then oem, the kit only comes with bushings thoe.
Comment
-
Mine is seized on somehow....I banged the shit out of it and still no luck..
Yes my name is Dang, Don't use in vain
1992 Honda Accord EX (Coupe/Bordeaux/Auto)
1992 Honda Accord EX (Coupe/Bordeaux/H22A MT)
2008 Honda Accord EXL (Coupe/SanMarino/6spd)
Comment
-
Good write up. I did mine yesterday in about 45 min.2013 Honda Fit Sport Alabaster Silver Metallic GE8
2013 Accord Sport Modern Steel Metallic CR2
CB9 http://www.cb7tuner.com/vbb/showthre...hlight=hostile
CR2 http://www.cb7tuner.com/vbb/showthread.php?t=197787
GE8 http://www.cb7tuner.com/vbb/showthread.php?t=199289
Comment
-
Originally posted by Shehzada View PostGood info here.
Just one question......can this be done while the car is on all 4 wheels.....or do I have to have it on jackstands.
Mine was on there pretty bad so I had to have them cut off...good luck.
Yes my name is Dang, Don't use in vain
1992 Honda Accord EX (Coupe/Bordeaux/Auto)
1992 Honda Accord EX (Coupe/Bordeaux/H22A MT)
2008 Honda Accord EXL (Coupe/SanMarino/6spd)
Comment
Comment