So I was bored waiting for paint to dry on another project and I decided to convert an old drill box into a toolbox for my trunk. Actually, I just decided to paint it and put padding into it since I was already using it as a toolbox.
Check out what I started with:
Then I primered one side after removing some paint and sanding.
I found some carpet gripper and put that on the top and bottom of the box to reduce rattling and sliding. Also note that no DIY is complete without a car manual in one picture:
I had a choice of painting the face gold or chrome. I decided to go with gold because Sir Mix-a-Lot likes it more.
Here's the really choice part. I put grip tape on the bottom so it wouldn't slide around in the trunk at all. I was thinking to myself, "Yo, wat bout dem homies at cb7tunizzle? I gots ta give da props, yo." In recognition of everyone here, I cut out a CB7 logo in the grip tape. Now that's real.
Check out what I started with:
Then I primered one side after removing some paint and sanding.
I found some carpet gripper and put that on the top and bottom of the box to reduce rattling and sliding. Also note that no DIY is complete without a car manual in one picture:
I had a choice of painting the face gold or chrome. I decided to go with gold because Sir Mix-a-Lot likes it more.
Here's the really choice part. I put grip tape on the bottom so it wouldn't slide around in the trunk at all. I was thinking to myself, "Yo, wat bout dem homies at cb7tunizzle? I gots ta give da props, yo." In recognition of everyone here, I cut out a CB7 logo in the grip tape. Now that's real.
Comment