98 Accord cross member question

[Lynx]

Will the subframe from a v6 fit the 4cyl? Or even the cross member?

I checked the parts numbers and there off by 1 number but both sub frames looked the same. But i really dont know enough to tell, lol.

The reason I ask is because its hard to find one around here and theres a shop down the road selling the subframe from a V6.

Anyone know?

[coupes]

It'll bolt up but the motor munt locations will be wrong.

[Lynx]

It'll bolt up but the motor munt locations will be wrong.

Would I be able to take the mounts off the old one and put them on the V6 cross beam?

[coupes]

I'm not 100%, but I don't think so. The mounts have different bases and I think different locations on the crossmember.

[Night Wolf]

they got completely different mounts & in different locations

[Lynx]

So would that be the only thing I would have to change over would be the mounts? I also noticed the drivers side radius rod is a diff part number then the V6 but I would assume I could use the ones from my 4cyl frame.

I would really like this to work because if it doesnt then I have to pay over $700 for a new cross member. Anything used around here is rusted out, only parts from down south are really good here but there very hard to find and sell quick so im hoping with a little work the V6 would fit.

[PR CB7]

the front subframe fits

the back the front holes fit but the back 2 holes are off, so yes but no

[Lynx]

the front subframe fits

the back the front holes fit but the back 2 holes are off, so yes but no

I would only need the front to fit, #1 and #9 on the diagram.

http://www.hondaautomotiveparts.com/...M+-+CROSS+BEAM