car wont start?

[drift878]

Ok i just replaced oring on my distribtor i marked it and everything and i put it back in and it did not start. i turned it 180degrees back and it did not start at all. what else can the problem be?

[midnight_1]

You're gonna need to be a little bit more descriptive. It really helps to have as much information as possible.

[drift878]

Ok i was putting on a new oring inside the distributor. So what i did was take the hole distributor off replaced the oring. When i was putting the distributor back on and it didn't start. I marked it to make it line up right the while i took it off. Now the car wont start at all i turn it back 180degrees back to hope that it catch but it didn't i did this like over 20 times. What can the problem be?

[ExplodingCake]

Are you serious 180 degrees?

[midnight_1]

Did you check that everything was still plugged in to the dizzy? Did you check to see if the rotor button came loose? Are your plug wires still on tight? Are you throwing any codes?

[drift878]

Well i found out the promblem. I took the distributor apart and find out the sensor's inside the distributor were cracked. So i hope it starts when i get the new part for it.

[HoNdAhEaDmIkE]

if that does not work which i think it should it could be you jumped timeing it happened to me when replaceing my dizzy. Just like to let you know If that don't work

[drift878]

I got the car started guys it was the three sensors that were cracked. I got a new distributor and that was the problem. thank for every one help.

[midnight_1]

that's what the site's for. Helpin people in need. That and hatin' on DSM!!!!!!!!!!!!!!!! (j/k)

[secondaryed]

hah stupid dsms