ECU Jumper for setting timing. plz help newb

[93tunerofdacb7]

Ok well sorry for the extreme newb question but where is the jumper at on the ecu to set the timing i looked but didnt see any extra connectors aside from whats already plugged in... ive searched but no thread gets as newb as this is.. lol so if you have pics plz and THANK YOU VERY MUCH.

also when setting timing i need to check it with the gun.. duh then i must shut the car off and adjust the dizzing.. correct then tighten it and start it up and check again.. leme know if thats right.

TIA

[93tunerofdacb7]

DEEV plz dont flame me on this.

[93tunerofdacb7]

Bump

[PhatAccord]

Ok well sorry for the extreme newb question but where is the jumper at on the ecu to set the timing i looked but didnt see any extra connectors aside from whats already plugged in... ive searched but no thread gets as newb as this is.. lol so if you have pics plz and THANK YOU VERY MUCH.

also when setting timing i need to check it with the gun.. duh then i must shut the car off and adjust the dizzing.. correct then tighten it and start it up and check again.. leme know if thats right.

TIA

blue 2 pin connector under dash by right kick panel...
if you dont see it hanging, its probably tucked up a rubber stay.
you dont have to shut the car off when adjust timing..just move the dizzy at small increments at a time..

[93tunerofdacb7]

Yep found it thanks well it runs like a champ now except there is a loud whining noise that gets louder as i increase speed... almost like i had a auto tranny thats going out.. btw its a manual..

[vietkid_2006]

Yep found it thanks well it runs like a champ now except there is a loud whining noise that gets louder as i increase speed... almost like i had a auto tranny thats going out.. btw its a manual..

whining is probably your alternator.