Power Door Locks Problem

[91hondaaccordex]

Ok I Really Need Help..the Other Day My Locks Wouldn't Lock But They Would Unlock..then They Went Completely Out So I Checked My Fuses & Nothing Was Blown..so I Got In My Car & Drove For A Few Minutes Then Tried Locking & Unlocking My Doors From The Switch & The Locks Worked..when I Got Home To Get Out I Tried Unlocking The Doors & The Locks Didn't Work..i'm Starting To Feel Like My Cars Possessed..what The Hell Is Going On..i Know The Actuator Still Works Because It Works But Stops So It Has To Be Something Electrical...can Somebody Give Me A Clue.

I Read Online That I Should Check The Soldering Point But What Would The Actuator If I'm Using The Main Lock Switch On Both Passenger & Driver Side & None Of The Doors Are Locking As If None Of The Doors Are Getting Power.

[CB7H22Los]

im having the same problem..mines use to always work but it would blow out the fuse after awhile..i would replace the fuse then until it eventually gave out completely and the fuse is still in good condition...anyone have any ideas?

[Restless]

The same BS is happening to mine

[EJX_Michael]

Take your drivers side door panel off and remove the box that's in the door. This is the power lock control unit, either re-flow the solder points on the board or get a unit out of a CB from the junkyard.

Its a common problem, same thing happened to me, I re-soldered mine and haven't had a problem since.

[CB7H22Los]

haha i must've had bad luck because i bought 2 diff. ones from jy's and neither worked...so i might go ahead and do what you mentioned..

[Tippey764]

Take your drivers side door panel off and remove the box that's in the door. This is the power lock control unit, either re-flow the solder points on the board or get a unit out of a CB from the junkyard.

Its a common problem, same thing happened to me, I re-soldered mine and haven't had a problem since.

I had the same problem with my sedan and did exactly this. Problem solved

[Eddy Mac]

I had the same problem but it wasn't in my 92 , it was in my 94. The problem i had was the locking unit itself. in the 1994 if you unlock the car from the passenger side it unlocks all doors, in the 1992 it is the driver side that controls the doors. I switched the one in the 94 passenger side and it all worked like new. i think i only paid $15 from the junkyard. So if you pick up the driver side for your cb might work. maybe give that a try? good luck

[92 OEM]

I had the same problem. Sometimes my passenger lock would work and sometimes it wouldn't. Could be the Actuator Motor themselves. Check if you get power to the Actuator Motors. Take off the door panels put volt meter on wire to the unit, you should get +12 and them -12. If that is ok, check motors by giving them power. I did this and found that my passenger motor would only work sometime. Order new motor from ebay for ~$7. Works like a charm.

[Chris2388]

Take your drivers side door panel off and remove the box that's in the door. This is the power lock control unit, either re-flow the solder points on the board or get a unit out of a CB from the junkyard.

Its a common problem, same thing happened to me, I re-soldered mine and haven't had a problem since.

My power locks arent working at all and the fuse is still good. Im gonna try this I sure hope it works because its the only electrical problem my car has rite now.

[91hondaaccordex]

I made a video ill post it up & show yu how to fix it.

[Chris2388]

I made a video ill post it up & show yu how to fix it.

That would be great. Im so annoyed that my power locks dont work.