will this work?? gas clean up......

[manny38special]

ok so here is my theory and it might have been done before but who knows i can't find anything like this???
ok so im low on gas and i tend to run a bit rough when i am low so i guessing dirty fuel. OK BARE WITH ME, what if i disconnect the line that leads to the fuel injectors here is a pic.....

then attempt to start the car thus rushing the old fluid thru that line onto the ground. And wait until it either comes out clearer or run out completly??? WILL THIS HAVE A SIDEAFFECT WILL THIS WORK?????

[manny38special]

BTW i have done the seafoam stuff and even lucas here and there. I even have a new oem fuel filter, but will this be more effective in taking some of that junk gas out.
ALL REPLIES GREATLY APPRECIATTED..

[EJX_Michael]

With a new fuel filter you will probably just spit clean gas onto the ground. Take the fuel rail off and check the little filters in the tops of the injectors.

[manny38special]

is it hard to take off the fuel rail? and if the little filters are dirty how do i clean them? thanks for the reply

[EJX_Michael]

Take that main line off, then there are 3 nuts holding the rail down. They are behind it if I remember correctly.

You may want to replace the injector seals while you have the rail off.

To clean the little filters just take them out of the top of the injector and dunk the filter in some seafoam or carb cleaner.

[manny38special]

INJECTOR SEALS?
where do i buy those?
(what you are trying to say pretty much is that if the fuel filter stays up to date then gas should get cleaner and cleaner)

[EJX_Michael]

INJECTOR SEALS?
where do i buy those?
(what you are trying to say pretty much is that if the fuel filter stays up to date then gas should get cleaner and cleaner)

What I'm saying is if you put a new fuel filter in, any gas that comes out of that filter should be clean.

[pedroalcala]

yea clean your injectors, put take them out...
BTW what kind of gas octane are you using?