A/tproblem, Code 8 ?

[eljhonyboy]

somebody know what its the CODE 8 on transmission code?

[tutsuo]

somebody know what its the CODE 8 on transmission code?

More information would be great, but looking around iv found that Code 8 is either TCU or Shifting Solenoid issue.

source : http://techauto.awardspace.com/transmission.html

[eljhonyboy]

thanks for the help my friend,
i found this on a special software ONDEMAN5

FAULT CODE IDENTIFICATION
Fault Code No. (1) Indicator Light Condition (2) Probable Cause (3) (4) (5) Symptom
1 Blinks Defective Lock-Up Control Solenoid "A" Lock-Up Clutch Does Not Engage Or Remains Engaged, Unstable Engine Idle Speed
2 Blinks Defective Lock-Up Control Solenoid "B" Lock-Up Clutch Does Not Engage
3 Blinks Or Remains Off Defective Throttle Angle Sensor Lock-Up Clutch Does Not Engage
4 Blinks Defective Speed Sensor Lock-Up Clutch Does Not Engage
5 Blinks Defective Shift Position Console Switch Lock-Up Clutch Does Not Engage Fails To Shift Other Than 2nd To 4th Gears
6 Off Defective Shift Position Console Switch Lock-Up Clutch Does Not Engage, Lock-Up Clutch Engages & Disengages, Fails To Shift Other Than 2nd-4th Gears
7 Blinks Defective Shift Control Solenoid "A" Fails To Upshift, Remains In 4th Gear
8 Blinks Defective Shift Control Solenoid "B" Remains In 1st Or 4th Gear
9 Blinks Defective NC Speed Pulser Lock-Up Clutch Does Not Engage
10 Blinks Defective Coolant Temperature Sensor Lock-Up Clutch Does Not Engage
11 Off Defective Ignition Coil Lock-Up Clutch Does Not Engage
14 Off Shorted Or Open Wire, Wiring Between PGM-FI ECU & ATCU, Defective PGM-FI ECU Transaxle Jerks Hard When Shifting
15 (6) Off Defective NM Speed Sensor Transaxle Jerks Hard When Shifting
(1) Number of blinks from "S" light (1991 models) or "D4" light (1992 models) on instrument panel with jumper wire installed in service check connector.
(2) This is "S" light (1991 models) or "D4" light (1992 models) condition without jumper wire installed in service connector.
(3) Check specified component for probable cause. Also check wiring and connections for the specified component.
(4) If transaxle fails to shift from Park with brake pedal depressed, check brakelight signal. See BRAKELIGHT SIGNAL under TROUBLE SHOOTING.
(5) If lock-up clutch does not engage or does not cycle on and off, check A/C signal. See A/C SIGNAL under TROUBLE SHOOTING.
(6) Fault Code 15 does not necessarily indicate an electrical problem, as fault code may also be caused by an internal transaxle problem.

[tutsuo]

thanks for the help my friend,
i found this on a special software ONDEMAN5

FAULT CODE IDENTIFICATION
Fault Code No. (1) Indicator Light Condition (2) Probable Cause (3) (4) (5) Symptom
1 Blinks Defective Lock-Up Control Solenoid "A" Lock-Up Clutch Does Not Engage Or Remains Engaged, Unstable Engine Idle Speed
2 Blinks Defective Lock-Up Control Solenoid "B" Lock-Up Clutch Does Not Engage
3 Blinks Or Remains Off Defective Throttle Angle Sensor Lock-Up Clutch Does Not Engage
4 Blinks Defective Speed Sensor Lock-Up Clutch Does Not Engage
5 Blinks Defective Shift Position Console Switch Lock-Up Clutch Does Not Engage Fails To Shift Other Than 2nd To 4th Gears
6 Off Defective Shift Position Console Switch Lock-Up Clutch Does Not Engage, Lock-Up Clutch Engages & Disengages, Fails To Shift Other Than 2nd-4th Gears
7 Blinks Defective Shift Control Solenoid "A" Fails To Upshift, Remains In 4th Gear
8 Blinks Defective Shift Control Solenoid "B" Remains In 1st Or 4th Gear
9 Blinks Defective NC Speed Pulser Lock-Up Clutch Does Not Engage
10 Blinks Defective Coolant Temperature Sensor Lock-Up Clutch Does Not Engage
11 Off Defective Ignition Coil Lock-Up Clutch Does Not Engage
14 Off Shorted Or Open Wire, Wiring Between PGM-FI ECU & ATCU, Defective PGM-FI ECU Transaxle Jerks Hard When Shifting
15 (6) Off Defective NM Speed Sensor Transaxle Jerks Hard When Shifting
(1) Number of blinks from "S" light (1991 models) or "D4" light (1992 models) on instrument panel with jumper wire installed in service check connector.
(2) This is "S" light (1991 models) or "D4" light (1992 models) condition without jumper wire installed in service connector.
(3) Check specified component for probable cause. Also check wiring and connections for the specified component.
(4) If transaxle fails to shift from Park with brake pedal depressed, check brakelight signal. See BRAKELIGHT SIGNAL under TROUBLE SHOOTING.
(5) If lock-up clutch does not engage or does not cycle on and off, check A/C signal. See A/C SIGNAL under TROUBLE SHOOTING.
(6) Fault Code 15 does not necessarily indicate an electrical problem, as fault code may also be caused by an internal transaxle problem.

Ah good