How much would it cost.....?

[ZeRoCooLCB7R]

My 91 ex coupe left front bearing is broken.I had to move the car into the yard last night and man it burnt the hell out of my clutch.The car didn't want to go when i turn my wheel.Well i got it up on jack stands and the left front wheel is wiggling.It ate up the crap of half my rotors.I was just wondering how much i would be spending if i did it my self.Do i have to get a whole new spindel thingie?Also on the same side the steering rack boot is leaking all the grease.Do i have to also purchase a remanufactured rack & pinion?
Thanks for the help guys.

[trah]

if you did it yourself you would need a press and press out that bearing. most people use a torch and heat it up and hammer it out. DONT DO THAT it will cause it to expand and when you put the new one in it'll fall out and you would have to buy a new arm. its nto very hard just need the tools. i think you would need a star tool to remove the plate on the spindle.

[hemlockz]

you could probably take a complete assembly in good condition from a junkyard for less than 100 bucks and wouldnt have to worry about pressing the hub and bearing

[ZeRoCooLCB7R]

you could probably take a complete assembly in good condition from a junkyard for less than 100 bucks and wouldnt have to worry about pressing the hub and bearing

Yeah, thats what i thought about doing.Junkyard for under 100.Hmmm..might just work. Won't i mess up my alignment disassembling that part?

[Spartan1987]

Driving on it probably already did that. You will need an alignment period now. Go for the Junkyard special for this.
Good Luck

[Night Wolf]

I bought a bearing hub for like $60 & some high end bearing grease. its easy to install. the bearing already comes in the hub. I just have to bolt it on.

so go to autozone & ask for the price