vtec head converison????

[heavyhitter27]

i was wondering if it would be worth it to swap an h22 head on a f22 dohc or f20a

[deevergote]

Yes and no... if you have the block and can get the head cheap, go for it. If you plan on spending any serious money on it, then no. You'll have the rev-limits of the blocks (or displacement, as far as the f20a goes) so you won't be able to enjoy the full potential of the H22 head.

[quickangel93]

deev what about use a h23 head on a f22 block. any difference? will it fit?

[NAiL05]

deev what about use a h23 head on a f22 block. any difference? will it fit?

You really should search more and look around in the forum. Since your off of n00b status you should see threads about this all the time in the swaps section or whatever it is in. Search it under hybrid. Yes the H23 will fit on an F block and quite a bit of people run it on this site.

[m-tec93accord]

yes it will fit, but u need a f23 head gasket n fill in a coolant/oil port(or watch niaggra falls)

[m-tec93accord]

Yes the H23 will fit on an F block

funny that this is what u said cause theirs a thread w/that exact same title; was made by mister hybrid himself=wikked

[Fuzz]

I like how much conversions can be done with the CB7s. You would think just about any motor would fit into it!

I am going to miss my Vtec in the Winter, but my buddy Steve has already been whining about wanting to put a H22 in it.

I've driven one, they are bloody fast, but... for a tracking application... lots of money down the drain... Turbo seems easier, especially since I can get F22 motors like no tomorrow... (Very, Not so Limited Supply).

Hopefully when I get out of Noob Zone, I will be able to find out what some reason differences in the numbers are between a Turbo, or H22 Motor.