brake swap question

[jdmtrakstar]

i know people have the diy out in this site but i was wondering can i just use the brake lines,calipers,and the wheel hubs of a disc setup to swap them on a drum setup?i dont know if im missing any other parts but is because i found a ex that a friend of mines is parting out and well im really trying to get his disc setup and well just wondering if thats possible since he doesnt want to leave his car in jackstands for safety reasons,aka towing..and well i was also thinking what you guys recomend to get from his ex since my car is an lx.let me know what you guys think....

[quickangel93]

you pretty much use all the brake lines, just that one line thats hooked on the body and then that hose goes to the caliper in the rear you'll need to fabricate. everything else should hook right up.

[jdmtrakstar]

fabricate?which parts should i fabricate wouldnt the caliper bolt right on?

[slick]

Check they DIY section for the rear drum to disc swap

[The G-Man]

You need the whole knuckle. Swap them on your car and then bolt your drums up to his.

[jdmtrakstar]

thanks you guys,i have read the whole thing and the thing is that my friend wont sell me the whole setup just the parts for the swap so im going to get the whole rear setup

[The G-Man]

thanks you guys,i have read the whole thing and the thing is that my friend wont sell me the whole setup just the parts for the swap so im going to get the whole rear setup

That does not make any sense.