So the other day i went to autozone to get a cap and rotor button. Will put everything in and to my make a long story short my dizzy sounded like it was grinding. Know today I put in a all honda Oem parts and went to go start the car again and it just cranks over. So would you all have any ideas. Also i went to honda and a new dizzy is about $500.00. Please HELP
-
Looking for the following parts.
jdm front bumper 92-93
Jdm front headlight 92-93
90-93 Oem C/f hood -
no...one can help aint this bout some s#i%Looking for the following parts.
jdm front bumper 92-93
Jdm front headlight 92-93
90-93 Oem C/f hood -
You probably installed it wrong, somehow.
Or you have the timing order out of whack.
CrzyTuning now offering port servicesComment
-
Maybe the contacts in the cap weren't ground the way they need to be, they should be just long enough to be tapped by the rotor. Anyway OEM honda is best anyhow
btw cap and rotor from honda is only like 10-20 bucks
on the stairs, she grabs my arm, says whats up,
where you been, is something wrong?
i try to just smile, and say everything’s fine.Comment
-
put the screw back on the rotor button?Comment
-
Cheapo buttons don't have screws, only the OEM ones. As much of a pain in the ass that screw is, I like to have it there.
Comment
-
Wait, what do you mean button? The rotor doesn't use a screw it just presses on there, but I'm sure you guys know that...I'm confused
on the stairs, she grabs my arm, says whats up,
where you been, is something wrong?
i try to just smile, and say everything’s fine.Comment
-
SOME distributors have a screw that hold down the rotor.Originally posted by accordaffair
CrzyTuning now offering port servicesComment
-
i know the civics do and it's been a while, but i thought the accords did too. i haven't fucked with an accord dizzy in 2 or 3 years and that's a lot of weed and alcohol since then, so who knows what they have. it has a flat side anyway, so it probably wouldn't matter much, it would still be in place, but just a thought.
when people fuck up simple tasks, it's usually no fucking telling what is wrong.Comment
-
I've had both.Originally posted by fizzbob7
I had it narrowed down as to which dizzy's had it and which didn't. But I don't remember anymore.
CrzyTuning now offering port servicesComment
-
I know my H22 dizzy has the screw. I THINK the Accord ones do as well. I use a rotor button for a 90-91 Accord with the H22, and it has no screw. Just a metal clip on the flat side to hold it on. Holds it fairly well, but the screw is an added safety measure!
Comment
-
My 90lx and my 93ex do not use a screw to hold the rotor
My brothers 98 civic ex does
My 93's dizzy is OEM honda,and when I replaced the rotor with an oem honda replacement it still didn't, so I imagine accords do not....unless you have some aftermarket piece maybe?
So anyway I think I've gone off topic
on the stairs, she grabs my arm, says whats up,
where you been, is something wrong?
i try to just smile, and say everything’s fine.Comment
-
ok so if i buy the new honda cap and rotor button and the car still doesnt start what should i do. I have the firing order One starts at the 6' o clock postion and the it goes clockwise. I was told it could be the ignighter. But i dont see how...... Also in one in Ohio just lookingLooking for the following parts.
jdm front bumper 92-93
Jdm front headlight 92-93
90-93 Oem C/f hoodComment
-
Igniters can be blamed for no start situations, coil too
on the stairs, she grabs my arm, says whats up,
where you been, is something wrong?
i try to just smile, and say everything’s fine.Comment
-
I just took my dizzy of and I saw a little pool of oil leak out (see photo), is this normal? The car wont start even with the new dizzy. I haven't checked the spak plugs yet but I'm expecting them to be covered too. Would this stop the car from turning over?Attached FilesComment
-
Comment