Problems rolling quarter panels

[4cc0rdcb3]

I was gonna try and roll my quarters today, but ran into a few problems.

Problem 1: Mounted the roller tool on the hub, but the roller was way up into the quarter panel, so no rolling could be done.

Problem 2: Loosened the suspension so it came further down, but now the roller tool hits the upper control arm, and upper part of the knuckle.

Anyone have any input on how I can get this done?

[Accordolictx]

I've never used the roller tool so I'm not sure how it works. Can you take the wheels off or raise the car in the rear to see if the wheels drop down alittle for more room? You may have to use a baseball bat. That's what I did.

[slammed4thgen]

isnt the arm adjustable?

[4cc0rdcb3]

isnt the arm adjustable?

Thats a negative...

I found no way of adjusting the arms

[Luna92]

Do what the old hot rodders use to do a throch and a baseball bat! LOL where did you get a rolling tool?

[Macaqueistrong]

Thats a negative...

I found no way of adjusting the arms

Does it look like this? ^^^ Whats the brand of the roller that you are using? There has to be some way that it can be adjusted. We need to fit those bbs on right now!!!

[blazenem]

i used a jack handle and a rag lol

[Luna92]

i used a jack handle and a rag lol

What you do just push against the tire and fender?

[sleepygreen]

cant understand it but you get the idea,...
http://www.youtube.com/watch?v=DDTK9IjKIYU

[blazenem]

What you do just push against the tire and fender?

yeah we jacked up the car a lil lowered it on the handle and the moved the car in reverse very slowly. you gotta find a pipe or something that is slightly bigger that your wheel gap whet the car sits normally. something thats not to big or too small. also the driver and the guy holding the pipe have got to listen to each other. the pipe guy has to pay attention and make sure shit dont move wrong. that how i did it but might not work for everyone...

[my 9t9d]

I used a bat but make sure its wooden so it can flex slightly...

[4cc0rdcb3]

Does it look like this? ^^^ Whats the brand of the roller that you are using? There has to be some way that it can be adjusted. We need to fit those bbs on right now!!!

Looked exactly like that, just had another name on it...

Hell yeah!!
I want those wheels on so bad

Guess Ill be trying either the pipe or the baseball bat method