Opening Bumper lights

[GearBangnAccord]

I'm having trouble opening my bumper light i melted one already any suggestions??

[ikayto]

here's one way



I used a dremel, but it tends to melt plastic also.

[F20A CB7]

Yep u got the rite idea meng.

I jus used my pocket knife. It worked fine. As u open it with the knife or w/e ur using, u gotta turn the blade a lil and move the blade down as ur openin it

[GearBangnAccord]

looks time consuming

[TypeG]

looks time consuming

if you're worried bout that, then you probably shouldn't bother. later.

[lummieCB7]

I'm having trouble opening my bumper light i melted one already any suggestions??

Don't you have a 90-91 front end? I thought those just unscrewed and separated easily.

[GearBangnAccord]

Don't you have a 90-91 front end? I thought those just unscrewed and separated easily.

u thought wrong those bitches are on tight i tried an exacto no good im hacksaw it 2moro

[JDMCB3Si]

did you read the DIY?!?!?!?!?

[F20A CB7]

Prehear oven @400, then turn down to 350 after 10min's, pop 1 in @ a time for @ least 5 min's.


Remove from oven, and start with the corners. Create a hole with something sharp and go from there. Giggle/wiggle the blade.


I have 9091 cb9 bumper lights, and I didn't even take me that long to 2, 20min tops

[GearBangnAccord]

Prehear oven @400, then turn down to 350 after 10min's, pop 1 in @ a time for @ least 5 min's.


Remove from oven, and start with the corners. Create a hole with something sharp and go from there. Giggle/wiggle the blade.


I have 9091 cb9 bumper lights, and I didn't even take me that long to 2, 20min tops

wiggle it just alil bit

[GearBangnAccord]

did you read the DIY?!?!?!?!?

u jnow wut mister i dont like ur tone I've read the DIY like i stated in the OP i melted one already just didn't want to make extra trips to the JY for bumper lights ok and if u got nothing useful/constructive to say just shut it.