*Help Just Installed red/Clears*

[h22a_4thGen]

i just installed them about 1 hour ago.. i checked it out after i installed em do all the blinkers and stuff work.. and its fine... till i start driving home..i noticed my front right turn signal was blinking really fast.. so i stoped and turned on my hazards the back rightside signal wasnt working.. so i didnt know wat i should do.... checked the connection seems fine.. i didnt even mess with the wires..but now i dunno wat to do... ne help would help ... but the back right turn signal dont work and the front and incar signal blinks fast .. THANKS !

[srsskyline]

when u swap it did you swap the sensor box? and the reason the front is blinking fast is because your back ones dont work.... so check ur bulbs to see if its burnt or somethin then check back here...

[h22a_4thGen]

yeap.. took the old sensor block to the new tails.. it worked fine when i was testing them... its wierd

[uncle_el]

did you consider checking the bulbs in the rear?

[Takeda]

had the same problem.. definitely check the rear bulbs

[h22a_4thGen]

i did.. it doesnt seem burnt out.. but i guess i should just buy a new one and replace and see wat happens eh.. wat did u guys do?

[clarksterdotcom]

or take one out from another signal lamp indicator to see if its even the bulb that is your problem..

[h22a_4thGen]

nope the bulbs not a problem.. its old so i replaced it with a new one ne wais.. and it wasnt it.. still the same problem...would it be the sensor box? kuz my old tailights had allota water in em lol.. and if it is.. how would i be able to fix it?.. i hate driving without a signal.. ppl think im being cocky and cuttimg them off and shit haha.. ppl get mad up here ez

[timmy0tool]

sorry to reiterate but make sure the bulbs are not busted. sometimes the filament looks ok but it really isn't making contact to each other. also check the bulb socket contact. corrosion sometimes hinders a good connection. remove it with a brush.

good luck!

[aarbug1]

check to see if they are the correct bulbs. look at the contacts make sure if there is 2 that your bulbs have 2 also not 1. i found out that the bulbs are different when i switched my tails also. just a thought.

[h22a_4thGen]

yea.. well it was wierd.. i just moved the bulbs around a bit put my hazards on and they seem to be working fine... dunno how that works.. but it looks good .. but sumtimes it would go off and then i have to move it around agian.. i think it has sumthing to do with the socket..but as of now.. its working great just a lil bright.. thanks for everything guys..