Which amp will do the job better

[pretty_ricky302]

ROCKFORD FOSGATE P6001BD PUNCH 600 WATT MONO AMP
1800 max power
300 watts RMS x 1 at 4 ohms
600 watts RMS x 1 at 2 ohms
2-ohm stable
CEA compliant
requires a 4-gauge wiring kit ? wiring and hardware not included with amplifier
MOSFET power supplies and outputs
MEHSA transfers heat efficiently from the MOSFET devices to the heat sink for high performance
TOPAZ eliminates ground loop noise
trans-ANA circuitry keeps preamp signal clean
NOMAD "intelligent" protection circuitry
variable low-pass crossover (35-250 Hz, 12 dB/octave)
variable Punch Bass boost with remote (0-18 dB at 45 Hz)
11-1/8"W x 2-1/2"H x 13-11/16"D




Directed Electronics' 1100D

Dynamic Power Rating: 1400 watts
S/N: > 80 dB
Freq. Range: 20-250Hz
Damping Factor: > 50
Input Sens.: 150mV to 8V
Rated Power @ 4 ohm: 425 x 1
Rated Power @ 2 ohm: 800 x 1
Rated Power @ 1 ohm: 1100 x 1
Crossover: var. 18dB low-pass
Bass EQ: Yes 8 dB
RCA Output: Yes, mono
Protection: T,S,D,R,O,L
T=thermal, S=short circuit, D=DC offset, R=reverse polarity, O=over/under voltage, L=status LED






SUBS are TWO KICKER CVR

[sonikaccord]

Voice-coil configuration?
If its one ohm, i would definately get the directed amp.
Do you have a specific power requirement?

[loud92CB7]

directed is gonna be mroe power even at 2 ohms or 1 ohm. i would run the directed.

[pretty_ricky302]

I really like the ROck amp b/c of the bass knob. My backseat doesnt go down so i would have to pop the trunk to against.

[UrDoneSRH]

i would go fosgate.. not feelin the directed amps..

bass knobs are for noobs btw

tune your amp and leave it there

[Shaiyelito]

Directed 100%

[turbomaxx]

You can't go wrong with Directed Electronics

[SteveB]

What distortion %'age are these power rating at? Something useful? Something at least comparable?

[pretty_ricky302]

seems like the Rockford punch amp is doing a better job.