Announcement

Collapse

Please DO NOT Post In The General Section

From this point on until otherwise briefed, posting in the general section of Performance Tech is prohibited. The only thing to remain here will be the stickies. We would just delete this section, but that would cause unintended results.


The majority of the threads created can appropriately be placed in one of the Performance Tech sub-forums or Technical; and the posting of them here is detrimental to the activity of said forums. If you have any questions about where you need to place your thread PM me or one of the other mods.


For the most part you all have caught on without this post, but there have been a few habitual offenders that forced me to say this.


Everyone will get a couple of warnings from here on out, after that I just start deleting threads.

Again if you have any questions, PM me or one of the other mods.
See more
See less

((Help On Exhaust)) Duals Or Single Setup

Collapse
X
Collapse
 
  • Page of 2
  • Filter
  • Time
  • Show
Clear All
new posts
Previous 1 2 template Next
    #16
    well lets but it this way, well my friends mess around lot, We do highway racing and street racing so i can say kinda both in a way

    Comment

      #17
      Well in that case I would reccomend running 2.25" pipe. That will allow you to retain low end torque, while only comprimising a small piece of your high end horsepower.

      Comment

        #18
        I ight but since I doning a either all motor or a h22 swap wouldn't it just be better to do a 2.5 now than going back and doing, and whats the loss of just having 2.5 vs 2.25

        Comment

        Previous 1 2 template Next
        Working...
        X