Announcement

Collapse

Please DO NOT Post In The General Section

From this point on until otherwise briefed, posting in the general section of Performance Tech is prohibited. The only thing to remain here will be the stickies. We would just delete this section, but that would cause unintended results.


The majority of the threads created can appropriately be placed in one of the Performance Tech sub-forums or Technical; and the posting of them here is detrimental to the activity of said forums. If you have any questions about where you need to place your thread PM me or one of the other mods.


For the most part you all have caught on without this post, but there have been a few habitual offenders that forced me to say this.


Everyone will get a couple of warnings from here on out, after that I just start deleting threads.

Again if you have any questions, PM me or one of the other mods.
See more
See less

where to set adjustable cam gear?

Collapse
X
Collapse
 
  • Page of 1
  • Filter
  • Time
  • Show
Clear All
new posts
Previous template Next
    #1

    where to set adjustable cam gear?

    hey everyone just wanted some opinions. I understand that the best thing to do is set it on a dyno but im just trying to get some ideas. im running bisi 10.5-1 pistons and bisi stage 2 cam. thanks everyone
    Tags: None
    #2
    zero, it needs to be dialed in.
    I <3 G60.

    0.5mm Oversized Stainless valves and bronze guides available. Pm me please.

    Comment

      #3
      ok i have an aem trutime gear and im running the AEM EMS. I am just wondering what amount of retard or advance people are running and what they think.

      Comment

        #4
        dialed in with a timing wheel on the crankshaft.
        I <3 G60.

        0.5mm Oversized Stainless valves and bronze guides available. Pm me please.

        Comment

          #5
          I am running 3deg advance. On the AEM its a notch and a half past the 0 mark. I noticed that when I went to have my delta 272 tuned, I started off on 0 and had 131hp (its an automatic mind you) and 123tq. I put it on 3 and now I am pushing 129hp with 125tq. That isnt exactly right but its a close resemblance to what it did for me. But until you are tuned, set it on 0 and you will be fine.

          Comment

            #6
            Leave it at Zero, all it does is shift the powerband around if you are not truly tuning. Retarding gives you power on the highend, and advance on the lowend

            Comment

              #7
              ok im going to be getting to the dyno here soon. im waiting for my ITB's. thanks everyine ill keep you posted

              Comment

              Previous template Next
              Working...
              X