ok i have a few questions.i have rebuilt many motors but never a block with frm sleeves.the block im building is clean, sleeves are smooth and fine.my questin is does this block need to be honed?i have heard from a few people that the frm sleeves cannot be honed and that i should just change the rings out is this true?also i need a decent rebuild kit and everywere i look is some cheap ebay crap.thanks for the help.
Announcement
Collapse
Please DO NOT Post In The General Section
From this point on until otherwise briefed, posting in the general section of Performance Tech is prohibited. The only thing to remain here will be the stickies. We would just delete this section, but that would cause unintended results.
The majority of the threads created can appropriately be placed in one of the Performance Tech sub-forums or Technical; and the posting of them here is detrimental to the activity of said forums. If you have any questions about where you need to place your thread PM me or one of the other mods.
For the most part you all have caught on without this post, but there have been a few habitual offenders that forced me to say this.
Everyone will get a couple of warnings from here on out, after that I just start deleting threads.
Again if you have any questions, PM me or one of the other mods.
The majority of the threads created can appropriately be placed in one of the Performance Tech sub-forums or Technical; and the posting of them here is detrimental to the activity of said forums. If you have any questions about where you need to place your thread PM me or one of the other mods.
For the most part you all have caught on without this post, but there have been a few habitual offenders that forced me to say this.
Everyone will get a couple of warnings from here on out, after that I just start deleting threads.
Again if you have any questions, PM me or one of the other mods.
See more
See less
h22a4 rebuild questions
Collapse
X
-
Originally posted by bruno8747 View PostCheck the cylinders, Once they are truly round and not ovaled then you are fine to just re-ring. Its not that you cant hone the FRM its more work to find all the tools to do it than a regular steel sleeve motor.
Comment
Comment