Announcement

Collapse

Please DO NOT Post In The General Section

From this point on until otherwise briefed, posting in the general section of Performance Tech is prohibited. The only thing to remain here will be the stickies. We would just delete this section, but that would cause unintended results.


The majority of the threads created can appropriately be placed in one of the Performance Tech sub-forums or Technical; and the posting of them here is detrimental to the activity of said forums. If you have any questions about where you need to place your thread PM me or one of the other mods.


For the most part you all have caught on without this post, but there have been a few habitual offenders that forced me to say this.


Everyone will get a couple of warnings from here on out, after that I just start deleting threads.

Again if you have any questions, PM me or one of the other mods.
See more
See less

Will this H23a head be ok?

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    Will this H23a head be ok?

    I was just searchin on ebay and i found this cylinder head off of some guys prelude and i was wonderin if him saying it is ok should be believable. Thanks for the help

    heres the site:

    http://cgi.ebay.com/ebaymotors/h23-h...16203259QQrdZ1


    Burrito Bandidos: It will change your fuckin life

    #2
    ya its at 40 bux right now so i figured good deal ill be watchin it till tommorow if it stays bout the same i figure why the hell not.


    Burrito Bandidos: It will change your fuckin life

    Comment


      #3
      Expect to spend $300+ just to reshape the chamber on the cylinder that dropped the valve. H23 heads don't go for that much in proper working shape, I would pass on this one.

      CB7Tuner member #38

      Comment


        #4
        alright i will then thanks for the help


        Burrito Bandidos: It will change your fuckin life

        Comment

        Working...
        X