Announcement

Collapse

Please DO NOT Post In The General Section

From this point on until otherwise briefed, posting in the general section of Performance Tech is prohibited. The only thing to remain here will be the stickies. We would just delete this section, but that would cause unintended results.


The majority of the threads created can appropriately be placed in one of the Performance Tech sub-forums or Technical; and the posting of them here is detrimental to the activity of said forums. If you have any questions about where you need to place your thread PM me or one of the other mods.


For the most part you all have caught on without this post, but there have been a few habitual offenders that forced me to say this.


Everyone will get a couple of warnings from here on out, after that I just start deleting threads.

Again if you have any questions, PM me or one of the other mods.
See more
See less

Intake Manifold

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    Intake Manifold

    Hey dont know if this is dumb or not, but I was fooling around with an H23 mani I have and was wondering if it would be possible to run the manifold without the butterfly valves. I mean just the upper and lower plenum only. No butterfly valve componet at all. Shorter distance for air to travle. I tried it and the Idle sensor nipples hit the lower plenum. Just wondering if there would be anyway to fabricate it, or make it work.

    Thanks!
    Last edited by 91accord1; 12-19-2006, 08:28 PM.
    5th Gen. Lude Team I <3 JDM

    #2
    www.blacktrax.net sells spacers so this doesn't happen, they also offer porting and stuff like that for h series manifolds, check it out
    Members Ride

    Comment


      #3
      http://www.blacktrax.net/BTP_IMS.html

      check that out
      Members Ride

      Comment


        #4
        /\/\/\/\PERFECT Blackcb7!! Thanks Dude!! /\/\/\/\
        5th Gen. Lude Team I <3 JDM

        Comment

        Working...
        X