as the title states, still cant get the bugger to work! i found the walkthrough on the uberdata forums and followed it multiple times, but all the pictures are down so i cant see what im doing wrong....i really need to finish this today, im going out of town tomorrow morning and have to take a break from the car....
ive got everything connected, the chip is in the burner, and its set to willem, and the correct chip setting, but the Electronic ID button is grey, and it almost seems like i have no connection with the serial port even though its all connected...the thing thats confusing me is the dipswitch diagram on the software is backwards when i compare it to mine (1-12 is 12-1 and ON is on the opposite side of the board)
ive tried everything and still no results...is there a connection i need to jump? i thought the pin 3- pin 31 connection was only for ATMEL chips?
ive got everything connected, the chip is in the burner, and its set to willem, and the correct chip setting, but the Electronic ID button is grey, and it almost seems like i have no connection with the serial port even though its all connected...the thing thats confusing me is the dipswitch diagram on the software is backwards when i compare it to mine (1-12 is 12-1 and ON is on the opposite side of the board)
ive tried everything and still no results...is there a connection i need to jump? i thought the pin 3- pin 31 connection was only for ATMEL chips?