Announcement

Collapse

Please DO NOT Post In The General Section

From this point on until otherwise briefed, posting in the general section of Performance Tech is prohibited. The only thing to remain here will be the stickies. We would just delete this section, but that would cause unintended results.


The majority of the threads created can appropriately be placed in one of the Performance Tech sub-forums or Technical; and the posting of them here is detrimental to the activity of said forums. If you have any questions about where you need to place your thread PM me or one of the other mods.


For the most part you all have caught on without this post, but there have been a few habitual offenders that forced me to say this.


Everyone will get a couple of warnings from here on out, after that I just start deleting threads.

Again if you have any questions, PM me or one of the other mods.
See more
See less

My dyno #'s.

Collapse
X
Collapse
 
  • Page of 1
  • Filter
  • Time
  • Show
Clear All
new posts
Previous template Next
    #1

    My dyno #'s.

    -170HP SAE
    -205TQ SAE
    -9PSI
    -T25
    -NEPTUNE


    I've got to go through all of my piping. I think there are a few leaks around my shity welds. I was using a turbo xs manual boost controller and couldn't get 10PSI out of it. The datalogger showed the boost drop to 4.5PSI by 7,000RPM! The dyno graph shows the nightmare, too. Hope to have some good news soon.
    Tags: None
    #2
    The torque isn't looking bad, but the HP deffinitly fropped up high when the boost dropped. Hope you get it straight soon. Looks like that should be one badass setup when it's right

    My Accord History:
    91 EX 2dr : 91 EX 2dr : 91 LX 4dr : 93 EX 2dr : 86 LXi 2dr : 92 LX 4dr : 92 EX 4dr

    -Patrick

    Comment

      #3
      spray some soapy water around the welds to make sure there arent any leaks and around the coupler entries too.

      Comment

      Previous template Next
      Working...
      X