Announcement

Collapse

Please DO NOT Post In The General Section

From this point on until otherwise briefed, posting in the general section of Performance Tech is prohibited. The only thing to remain here will be the stickies. We would just delete this section, but that would cause unintended results.


The majority of the threads created can appropriately be placed in one of the Performance Tech sub-forums or Technical; and the posting of them here is detrimental to the activity of said forums. If you have any questions about where you need to place your thread PM me or one of the other mods.


For the most part you all have caught on without this post, but there have been a few habitual offenders that forced me to say this.


Everyone will get a couple of warnings from here on out, after that I just start deleting threads.

Again if you have any questions, PM me or one of the other mods.
See more
See less

Ecu Control?

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    Ecu Control?

    Aites guys just need to know if any of u used ecu control before to tune your car.... i know MRX has but i couldnt get a hold of him on aim.....
    or if anybody know a site on how to use it? cuz ive been trying to use mine but i couldnt get it to work..... thanks

    #2
    explain what u've done so far. Got the correct com ports set up and all? I'll re-hook mine up tomorrow and let u know the settings
    Knowledge is power...in EVERY sense of the word

    FSAE (F Series Accord Enthusiasts) ..."A dying breed thats taking it to the next level" #12

    Comment


      #3
      forum.pgmfi.org

      Comment


        #4
        yea i got the com ports right and i clicked on uberdata obd1, clicked on stock narrowband for o2 sensor.....

        Comment


          #5
          port speed should be at 38400

          and after you press "connect" your pressing "start logging" right? Mine is on com port 4 by the way

          and if u haven't manually set the com port for it go to Control Panel>System>Hardware>Device Manager>Ports(COM &LPT)>USB Serial Port

          double click, change "bits per second" to 38400, then click advanced settings and set the com port to 4

          make sure all thats done first
          Knowledge is power...in EVERY sense of the word

          FSAE (F Series Accord Enthusiasts) ..."A dying breed thats taking it to the next level" #12

          Comment

          Working...
          X