I have a question

[caveman]

Will a h22 transmission bolt up to a stock f22 sohc non vtec and will a h22 euro intake manifold bolt up to a f22 sohc non vtec? thanks for the help

[JoshM]

Will a h22 transmission bolt up to a stock f22 sohc non vtec

Yes.

and will a h22 euro intake manifold bolt up to a f22 sohc non vtec?

No.

[Brandoncb7]

The transmission will bolt up but i'm not sure about the euro mani. I want to say it will but i'm not 100%. You'll have shorter gearing and your gas mileage will go down with the H tranny but most people say it's more fun.

[caveman]

well its for my turbo setup....i was going to do a h22 turbo but i am thinking i am going to just do a full built f22 sohc non vtec turbo.....i am also trying to find out if h22 rods will work in the f22 block too

[Night Wolf]

it is fun. till your on the highway doing 80mph at 4000RPMs lol

[NAiL05]

Just buy forged internals if your gonna have a "built engine". They can custom machine what bore and stroke you need by request. Takes time though.

[caveman]

Just buy forged internals if your gonna have a "built engine". They can custom machine what bore and stroke you need by request. Takes time though.

yeah i think i am just going to run arias/bisi pistons and crower rods with GE sleeves

[gloryaccordy]

Someone sells an adapter to put an H22 IM on an F22A head. IDK why u would want a Euro R mani for a turbo motor though

[caveman]

Someone sells an adapter to put an H22 IM on an F22A head. IDK why u would want a Euro R mani for a turbo motor though

because they are straight through design similar to after market intake manifolds like blox and skunk2

[caveman]

i will probably port the stock one and get rid of the butterflies or try to find a aftermarket one

[caveman]

so will the h23 intake manifold fit on a f22a

[caveman]

nevermind i search and figured out you can

[caveman]

what about the F23 intake manifolds do they flow better

[gloryaccordy]

what about the F23 intake manifolds do they flow better

F23As go on F22B SOHC motors. Not worth it

[Brandoncb7]

because they are straight through design similar to after market intake manifolds like blox and skunk2

You might as well look for a local custom sheetmetal fabricator that knows about airflow and everything try to fab one up. Look into Venom's products.