some advice for f22b dohc

[porc933]

ok as i had posted before i'm doing the f22b swap into my 91' lx, i have another prob. the brackets for one engine don't fit on the other so power steering and a/c will have to go. how do i go about doing this can i just disconnect them will that effect the steering sys w/o fluid going through it and the same for the a/c. and what belt should i use if i'm just using the altenator


thanks for the help guys

[phatdoughnut]

i stil have AC just used the accord braket and AC pump, i didnt even disconnect it, just took it off the rack moved it to the side. i dont have PS though i hate PS.

[akkordlayinkit]

Yea I did the same as Phatd with the A/C...but for the power steering I used the F22B pump / bracket and cut and unioned the F22B/F22A1 high pressure lines together. Works great.

Jay

[ZigenBallZ]

and you can use the Accord power steering pump and bracket...

you can only use 2 bolts of the 3 mounting points on the bracket and you need some washers or something for a spacer on the lower bolt... and you will need a slightly longer belt...

[spirit7623]

would that be a h23 belt?

[souldoubt]

would that be a h23 belt?

i used the accord ps brkt not the f22b. no problem w/ ps hose.
a/c is good.
belt wise use accord stuff (you model and year)

[CBL]

For No Ac Use The F22a1 W/o Ac Belt "5pk-0955"

[souldoubt]

what ecu are you using btw?? auto or manny?

[CBL]

IM USING A JDM P51 ECU.. iTS AUTO BUT WORKS FOR BOTH

[porc933]

i'm have a manual trans and i'm going to use the stock ecu until i can find better