Ok i'm doing my h swap finally lol. I have the motor all ready to go in just starting the wiring of the 4 wires. I know that the knock sensor goes to pin d4. Which I have done already I got the wire all the way to the knock sensor. But my knock sensor has 2 wires. So do I just route the black to a ground and the other to a d4 or both to d4 or what?
-
-
You have the wrong plug. It only has one wire. The only things that have two wires are the IAB and vtec oil pressure switch.
All the others are one wire. Find another connector on your harness.
steveLast edited by Stoner51; 02-09-2013, 08:47 AM.
-
It's not my harness that has 2 wires. I'm going the router of using the f22 harness. I'm just looking at the engine out of the car at the moment. And the knock sensor if your standing at the back of the block right below the intake on the upper left side of the oil filter. I don't know if maybe someone at one point put the wrong thing in. But this is where the knock sensor is and has 2 wires.Comment
-
Dumb question. I actually have a p28 I'm running this motor with that was tuned for this specific motor. Anyways I was told that the p28 doesn't have knock or egr valve is this true?Comment
Comment