i have a question about a swap on jdm h22 into 91 accord..... there is a sensor on bottom of oil filter, i believe it is the oil pressure sensor. the accord harness does not have that connector. do i have to wire that wire to the ecu also? if yes, what pin and connector should i wire that wire to? i think it is yellow/red??? can anyone help me out please??
-
The beginning of a new era............................
165 hp 149 ft. lb. torque sohc non vtec. then....
184 whp and 149 ft. lb. torque f20b stock now...... -
the accord harness has a oil pressure sensor are you sure it isn't the secondary intake sensor? -
im not sure, but it is the sensor on bottom of the oil filterOriginally posted by scg The beginning of a new era............................
165 hp 149 ft. lb. torque sohc non vtec. then....
184 whp and 149 ft. lb. torque f20b stock now......Comment
-
sorry i misread your post ya i just completed this swap last weekend and all i did was take the connector off the h22 harness and put it oon the f22 harness or just simply take the sensor out of the f22 and put it in the h22 hope this helpsComment
-
it looks like there isnt one on the f22 motor. it is a 91 accord lx. if i were to wire it to the ecu, what pin and connector should i wire it to?Originally posted by scg The beginning of a new era............................
165 hp 149 ft. lb. torque sohc non vtec. then....
184 whp and 149 ft. lb. torque f20b stock now......Comment
Comment