So,
My CEL has been on for too long...and in an attempt to bypass the KS I've some some HW.
this comes from pgmfi.org
I was wondering, if there was some way to fabercate something to feed this information to the computer? I was gonna run those voltages and RPM tables through a computer to see what the function would be by RPM, and then see if there wasn't some way to read the current RPM from the computer and run it through an electrical device and then output the correct voltage to the computer.
Any ideas?
My CEL has been on for too long...and in an attempt to bypass the KS I've some some HW.
this comes from pgmfi.org
Code:
Listed below is honda's table for appropriate knock noise @ WOT __RPM Knock Sensor __Voltage(Volts) 0 0.01953125 800 0.01953125 1600 0.01953125 2400 0.05859375 3200 0.29296875 4000 0.7421875 4800 1.23046875 5600 1.71875 6400 2.2265625 7200 2.71484375 8000 3.22265625 8800 3.7109375 9600 4.140625 10400 4.609375 11200 4.98046875 12000 4.98046875 12800 4.98046875
Any ideas?
