polyurethane?

[accord93racer]

ok ill post this question here now since i didnt get a response in the noob forum...ive read about people pouring polyurethane into their motor mounts to stiffen them...im getting ready to swap an h22 into my accord and i bought inserts for the accord mounts but they do not fit...so my question is where can i buy polyurethane or the mix or whatever? i know about inserts but i want the stuff that you can pour into the mounts and then let it harden...i know people on here have done that because ive read posts about them just not where to buy the stuff...thanks for any info...

[h22sparkle]

read this thread and get the 94 shore okay this is more than explanitory for you just read it carefully
http://www.cb7tuner.com/vbb/showthread.php?t=3033

[h22sparkle]

And its going to be this part number you need to get when you order it from mcmaster.com 94 Shore A Durometer - 1lb resin/hardener - p/n 8644K18
and you mix it but before you do that ducttape one side of the motormount i mean liquid proof it so that it doesnt seep out from the ends of the mount. Or go throught he tape you want it to stay in there and try to get as little as possible on your hands and such or on aything else.

The downtime for this procedure is approximately 24hours from the time you started that will be the time you can put em back on . Also make sure that you lay them down even flat at room temperature for best results good luck btw this has been done to a good amount of users on this site and they last and last.

[accord93racer]

the link to the DIY doesnt work...but thanks for the thread on where to get the stuff...im sure its pretty explanatory on how to do it...

[h22sparkle]

Just make sure you have the mounts out and have the motor supported with 2 jacks. One for the tranny the other for the actual motor with wood inbetween the oilpan and the actual jack supporting the motor.