A Plug for ECU

[93Akkord]

I need one for my H22...any one know the best place to get one besides a junk yard?? junk yards around me close at 5....but i get off of work at 5 Any ideas. I live in south fl..coral springs/ft. lauderdale area if any might have one in that area.

[v4lu3s]

either a junkyard or get someone to go to a junkyard for you unlesss someone on here has harnesses they arew willing to hack for you.

[93Akkord]

this is like the endless search...any one here of one wire vtec?

oh...and can I get the plug from any vtec obd1 ecu? I might see iff my dad can go to a junk yard and rip as many plugs out as possible and see if one works lol

[v4lu3s]

what exacrlty are you needing an entire plug for? did you tear one of them up with a VAFC install or something?

[93Akkord]

its the A Plug on the ECU....I'm having trouble getting one lol.

[v4lu3s]

i am curious why you need an entire plug??? i could see as a repair issue, but as a part of a swap i am not getting it...

[93Akkord]

Kinda like the picture below...I need the A plug...my swap didnt come with an ecu harness. all I need is this plug...and I have vtak!

[v4lu3s]

do you have a 96 up civic?
if not then that plug is a part of your factory chassis harness....

[93Akkord]

I just found that out there too...I talked to timmy...thats for helping me out and trying to figure out what I was saying.

[NAiL05]

DId your normal A plug fall off? Your suppose to use your stock harness...so all three plugs should be there. But why do you neeed an A plug??? corroded? missing wires? broke off?

[93Akkord]

the pin for the Vtec solnoid and the knock sensor arent inside the plugs...so I acutally needed the A and D plugs. I got them today. But yeah the pins need to be put on my old harness..which didnt have the knock sensor or vtec in the first place.

[cp[mike]]

remove the A4 pin from the extra harness plug, and open your harness and slide the pin in. then extend the wire all the way to the sensor.

[img]http://www.****.com/pics/pin_removal.jpg[/img]

[accordmaniac]

remove the A4 pin from the extra harness plug, and open your harness and slide the pin in. then extend the wire all the way to the sensor.

[img]http://www.****.com/pics/pin_removal.jpg[/img]

I learned something new!
Easier way to remove the pins from connectors.
Thanks.