Announcement

Collapse
No announcement yet.

One side lower

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    One side lower

    kyb agx + tein.. left front is about an inch lower then the right front everything brand new and properly seated

    #2
    ever in a wreck? Maybe frame damage
    ~Nick~
    FSAE (F Series Accord Enthusiasts) ..."A dying breed thats taking it to the next level" Lucky #13
    MR Thread:http://www.cb7tuner.com/vbb/showthre...ight=Grumpys93

    Comment


      #3
      Originally posted by Grumpys93
      ever in a wreck? Maybe frame damage
      it was lowered before I just replaced what I had.. No issue with the last setup

      Comment


        #4
        either the alignment is mess up (i.e caster, camber, etc) or one of the struts is leaky have a shop look at that


        To some people, a car is a car. But to people like us, its so much more than just a car. Its a getaway. Its our hiding spot. Its our comfort. Its an extension of ourselves.

        Comment


          #5


          Comment


            #6
            I did
            both upper control arms
            both lower ball joints
            both inner tie rods
            both outer tie rods
            both rotors
            both wheel bearings
            both sets of pads
            new struts
            new springs...........

            Its at least an inch.

            Comment


              #7
              is the higher side locked into the strut mounting? I figure that the higher side doesn't seem to look lowered, so possibly something to do with the set up over there? Hope it gets fixed.
              My Member's Ride Page (Do it)

              Comment


                #8
                Originally posted by CisForCB7
                is the higher side locked into the strut mounting? I figure that the higher side doesn't seem to look lowered, so possibly something to do with the set up over there? Hope it gets fixed.
                yeah they are both all the way down.. I will get pics when I pull of the wheel later

                Comment


                  #9
                  No offense but how much do you weigh. I worked with a guy that had a 3rd gen integra and it was about 1 lower on the driver side than the passenger side and he weighed about 350ish.
                  -1991 Honda Accord LX H22a-

                  Comment


                    #10
                    Originally posted by customchord
                    No offense but how much do you weigh. I worked with a guy that had a 3rd gen integra and it was about 1 lower on the driver side than the passenger side and he weighed about 350ish.
                    I haven't even driven the car yet. I am not fat either way though

                    Comment


                      #11
                      oh this guy drove the car for a couple of years. I think he should just right side drive it to even it out.
                      -1991 Honda Accord LX H22a-

                      Comment


                        #12
                        Did you bounce the car up an down to let it settle?

                        Comment


                          #13
                          release the ebrake and look at it again.

                          Comment


                            #14
                            drive it around the block and check again..

                            Comment


                              #15
                              Are there bumpstops on the car? If there are maybe one side has one and the other doesn't

                              SOLD!!
                              Boosted H22
                              375whp 298 ft/lbs at 15psi

                              MEMBERS RIDE THREAD<<<CLICK FOR VIDS AND COOL PICS

                              Comment

                              Working...
                              X