well the car is a 97 acura tl (g25
)
the car does not start
no spark
went by the book and measured:
coil
module
crk, cyl, tdc sensors
replaced ecu
nothing
get this, i was hooking up the can-2 obd2 scanner and when switching the key to "ON" position i cranked the engine and the bitch started, left it on, go up to temp, fans came on, a/c worked etc everything worked.
turned it off, then back on and it did again (success was reached happy face on)
happy removed the scanner, went to start it again and nothing (faaaaakkk)
in conclusion, the car will not start unless i connect the scanner, and if it the scanner wouldnt have cost me $400 i would have left it in the car
)the car does not start
no spark
went by the book and measured:
coil
module
crk, cyl, tdc sensors
replaced ecu
nothing
get this, i was hooking up the can-2 obd2 scanner and when switching the key to "ON" position i cranked the engine and the bitch started, left it on, go up to temp, fans came on, a/c worked etc everything worked.
turned it off, then back on and it did again (success was reached happy face on)
happy removed the scanner, went to start it again and nothing (faaaaakkk)
in conclusion, the car will not start unless i connect the scanner, and if it the scanner wouldnt have cost me $400 i would have left it in the car
that's the only thing i got .
Comment