Urgent Help Needed

[CBsevenDX]

Hey everyone, I changed my stock throttle body to an overbored that I recently bought. I took the TB sensor out, put it on the new one, connected everything back up just how it was before.

Now my check engine light is on and its idleing at about 3k. Whats the deal do I need to reset my ECU or mess with the idle

Someone help please, thanks.

Blaine

[alb_accord]

check the idle screw.....

does it do this all the time or only when the car is cold or what?

[CBsevenDX]

No my idle was fine with the stock TB now it idles more than it needs to (rich)

[NutBucket]

sounds like the TPS isn't aligned correctly.

[CBsevenDX]

how do i align it properly?

[Mista Juice]

exactly... just loosen the screws holding the tps in place and turn it until your idle gets where it needs to be..

[CBsevenDX]

just so i make sure i get this right, the TBS (the black peice on the back) i would basically just be rotating it slightly while the car is running? or while its off the car?

[Mista Juice]

i would do it while its running.. its not gonna damage anything, its just gonna adjust your idle.. plus you can see for yourself instantly if you are going the right way and how its effecting the idle..

[CBsevenDX]

couldnt solve my problem. i took the car down to the my local ricer shop. he said the throttle body i got was kinda chinsey. that kinda sucks because i bought it for 125 bones. but as far as i can tell, they should be able to take care of it, the question is for how much....that sucks

[CBsevenDX]

i got it on, its wonderful, can actually feel the difference

[NutBucket]

What kind of TB did you get?

[CBsevenDX]

its just a stock over bored, i guess it was done "professionally" i use that term loosely since it was missing some necessary pieces