Car sputters and dies cant rev

[Lakersfan24]

Ok so two weeks ago I made a post about my car pulling or sputtering while driving, at that time I had a code 9 and that was the dizzy. Well so far I have changed the dizzy brand new, distributor cap, rotor, wires, sparkplug wires, map sensor and injectors and coil. Well now my car does turn on but when I go press the gas pedal the car will not rev. The car sits at 1000 rpm and sounds good but when I go press on the gas it will start to shake and it dies. I can not figure out what is wrong with it, I all so switched my ECU from an PT6 to a PT3 and nothing same issue. I also do not have a CEL any more, it does not come on with either ECU. I did reset the ECU and nothing, I need some help I can not figure out whats wrong and I am frustrated now. Any help would be appreciated. thanks

[stretch JDM]

sounds like you may have bumped it out of time . this happens when you change the dizzy sometimes. loosen the bolts and bump the dizzy to set the timing.

[js593]

open your air intake system, check for carbon buildup on the throttle body inside the passages. Make sure your getting proper fuel pressure, sounds like your giving it gas, but its not getting enough, thus causing a stall. To me, this sounds like a fuel/air distribution problem (since you've already nulled out spark)