Main girdle Tq sequence

[SOHC-FTW]

Needing the main caps girdle sequence for an F22 i have the tq specs, but no sequence's.If anyone knows or has a link (I looked no luck as of yet) that would be appreciated very much.Thought it was cress crossed but i'm not a 100% sure on if they are or if the inner gets tq to different specs than the outer aswell.

['93CB7Ex]

came from the haynes 90-93 accord repair manual.

[SOHC-FTW]

came from the haynes 90-93 accord repair manual.

Thank you very much man my book is MIA.Are they just in sequence or is outer tq different than the inner?Or just tq in sequence Step 1 22 lb-ft/step 2 55 lb-ft.

[bobbycos]

nice, but do you have a low setting first then a high setting?

for example

1st go round at 25 foot pounds then 2nd go round at 65 foot pounds

[SOHC-FTW]

nice, but do you have a low setting first then a high setting?

for example

1st go round at 25 foot pounds then 2nd go round at 65 foot pounds

65 ft lbs?Thought it was 55?

['93CB7Ex]

not sure shitty haynes books dont say that they are staged torque. this is all it says. id wait for somebody to chime in with an oem service manual to confirm the sequence and torque.

[bobbycos]

65 ft lbs?Thought it was 55?

that was an example only

i gotta pull my manual (real Honda not Haynes) off the shelf

[SOHC-FTW]

not sure shitty haynes books dont say that they are staged torque. this is all it says. id wait for somebody to chime in with an oem service manual to confirm the sequence and torque.

Much appreciated either way bud.

[SOHC-FTW]

that was an example only

i gotta pull my manual (real Honda not Haynes) off the shelf

Please do that would be even better.

[bobbycos]

a reading from the "bible"

chapter 7-21


step 6

.....then tighten the bearing cap bolts in 2 steps.

in the first step tighten all bolts in sequence to 22 foot pounds then in the second step tighten using the same sequence to 52 foot pounds

the haynes pic is correct

too late at night to start the picture taking

[SOHC-FTW]

a reading from the "bible"

chapter 7-21


step 6

.....then tighten the bearing cap bolts in 2 steps.

in the first step tighten all bolts in sequence to 22 foot pounds then in the second step tighten using the same sequence to 52 foot pounds

the haynes pic is correct

too late at night to start the picture taking

That will do bud i appreciated ya'll.