92-96 Apexi WS catback on a accord?

[Losiracer2]

I picked up this exhaust last night for a really good price. Since the quality and tone of the exhaust on my H22 coupe was so nice, I figured I'd try and see if it bolts up and use it on my daily.

I haven't lifted the car up yet and lined up things. Right off the bat, I know the hangers are all off, so I'm cutting those off.

What else would I need to do you think to make it fit on a 4dr? Pipe extension? Looks like it had the same flange that bolts to the cat, and i recognized the B-pipe hangers being similar or the same on my Apexi WS2, just not sure of the length since I know Preludes are a bit shorter than Accords

If its too much work, i'll just sell it for a profit.

[cb9love]

i used a full aftermarket exhaust from a 97 prelude, in order for it too reach the back i only needed to extend the straight piece after the bend in the resonator. your right the hangers do not match up.
( i used a whole prelude for my swap and reused everything of it i could)

[Losiracer2]

i used a full aftermarket exhaust from a 97 prelude, in order for it too reach the back i only needed to extend the straight piece after the bend in the resonator. your right the hangers do not match up.
( i used a whole prelude for my swap and reused everything of it i could)

so the straight piece after the S bend, you extend that by what? 3 inches?

Does the Axle back portion need to be modded at all? Almost looks like that hanger will work, but i'm just guessing.

[cb9love]

I really don't remember how long the extension was, I used a piece of straight pipe and let the extra go over the old pipe like a sleeve.
The hangers are close but will not work with factory rubber hangers.
I used hangers i found at Autozone that had a series of holes in a strap that worked for adapting Accord underbody hangers to the aftermarket exhaust.