o2 sensor removal

[cb7TwitchBoy]

I don't know if you guys experience the same thing but is so hard to remove the o2 sensor even with the tool. The tool i used was the flex head oxygen sensor wrench i think ima use the socket instead, see how that goes today.

[sonikaccord]

I used a box end and it came right out. Give it some taps on the nut with a small hammer.

[F22Chris]

Take off the down pipe. Get a breaker bar or a cheater pipe then hit it with some PB Blaster. Proceed to step on or bounce on that shit till it breaks loose.

[cb7TwitchBoy]

Take off the down pipe. Get a breaker bar or a cheater pipe then hit it with some PB Blaster. Proceed to step on or bounce on that shit till it breaks loose.

I did that yesterday but with out the pb blaster, that think is a pain in the butt to take it off. I took off the nuts on the top and the one bolt on the side, the pipe is cut so it could just come off (this is the car i got for parts) and then i still need to take it off on my car as well.
Ima try the pb blaster or wd40 would work too im guessing.

[F22Chris]

If that fails, use heat

[cb7TwitchBoy]

If that fails, use heat

Good idea. I dont care about the other car because ima junk it after i take all the parts i need.