Alignment

[According2Aaron]

I searched the forums and found nothing on alignments. I've been told I could do my own not-as-accurate alignment, but it'd beat letting go of the wheel and the car swerving into on-coming traffic. So how would I do this? Any takers?

[NoSloCB7]

Its your wing...it isn't positioned correctly so it is making your car pull to one side

[deckeda]

Aaron, unless you've replaced some parts such as tie-rod ends or something is broken, it's likely already closer than you could get it yourself.

Like rickyduckworth sez, suspect tires first; at least it'll be an easy no-cost option to test by swapping.

[AccordManOut]

It could be the duct tape on the side.

[JaK FRoSTWhiTE]

Deev asked this question a while ago.
So it should be in teh Search option.

It could be the duct tape on the side.

If you go to "User CP" on the blue header (Top left corner)
It will take you to your control panel and theres going to
be a section there where you can Edit your Sig.

It will save you the hassle of always adding the same picture
in every post.... JFYI

[According2Aaron]

Wow, you jackasses sure are funny. Don't post unless you have something helpful to add. It's not my tires. It's because I just replaced my front-right upper control arm and ball joint. When I looked up how to replace the control arm they said I would most likely need to get the front end re-aligned and now I do. All I want to know is what I need to do to adjust the alignment myself. I don't want to hear bulls**t about my wing or vinyl, etc. Add something constructive or don't add at all. Thank you.

[91accord4door]

first off, not cool to make fun of you, whether it's anyone's taste or not, it's just not cool.....

something i noticed and forgot to mention, your front wheel is shoved back quite a bit, like you hit a curb pretty hard.......your caster is WAY off and i guarantee you that's the reason your car is pulling.......i had to replace basically the whole front end on that one side of the car i fixed.....dude hit a curb......bent pretty much every piece......if it's fixed, then show us some recent pics, because you'd have had to replace the front crossmember too......maybe the strut too.......

damn very good eye. that front wheels is def waaay to far back. look at the space from the front of your front wheel to the back of your front fender.....to big of a gap.

[91accord4door]

see the gap in this first pic is just to big.....notice in the 2nd pic the gap isnt so big. this is why your pulling so hard to the left.

[According2Aaron]

Well, the car didn't start pulling like that until after I replaced the control arm so I figured that was the cause. Wouldn't it be?

[According2Aaron]

That makes sense but how does that account for the wheel sitting too far back? =S