problem when shifting at high rpm

[chicohonda91]

sometimes when im hitting it from 1st to second gear it just wont go in. like the clutch is not pushed in, but if i shift slower then ill be fine. could it be the slave cylinder that has air in the line. the clutch and flywheel are brand new so i know is not that. any help appreciated.

[acrophobia]

did u install a new pressure plate? maybe the alignment is off on the clutch when installed

[mondojackal]

check the slave..my slave was cracked and it leaked..i had trouble on startup the clutch wouldnt engage..also, it wouldnt go into first unless i went into 2nd first
i still have that habit

[chicohonda91]

did u install a new pressure plate? maybe the alignment is off on the clutch when installed

yes clutch and pressure plate are brand new and the aligment on the clutch is fine cause i was there helping puttin everything on the car. but like mondojackal said it could be my slave cylinder. definately not leaking but ill try bleeding it first if not then ill probably get a new one and go from there. cause thats basically the only thing i didnt replace besides the master cylinder. thanks again for the info

[shawn.hayden]

do your shift cables feel loose? I had the exact same problem, and it turned out to be the gear box on top of the transmission (I got a whole new tranny)... if your shifter feels loose, its probably the gear box.

[KeeleDesign]

i have the same problem as this, my master cylinder is leaking and will be replaced, but i don't think thats the only problem./.

I have swaped my h22 from auot to 5 spd, and it just doesn't feel right, the gears aren't wanting to go in at all when getting on it hard, but will going slow, and their is no grinding, while trying to shift.

[accord junkie]

knda sounds like the synchros arent lining up right hard shifting can cause this or i should say power shifting