h22a vtec problem...

[nightrider93ex]

wow the problem had gone away for a while but it came back...wtf

[Riceburnin91]

if the knock sensor is not conected will the check engine light come on....?

[JDMjunkie]

yes

[NAiL05]

^^ yes to the dude above. And have you checked your timing/knock sensor yet?

[Riceburnin91]

i did do the timing on my car recently and its running like its restricting me to go faster

[nightrider93ex]

no...where exactly is the knock sensor?

[JDMjunkie]

the knock sensor is located above the oil filter and the black coolant line that runs on the back of the block. the easiest way to get to it is take the oil filter off or take of the intake manifold. i took the manifold off of my H22 in about an hour and a half and the sensor was right there. it was very easy to change. if you need a knock sensor i have one. also check the connections on the sensor and make sure its wired up to the right pin. i thought i needed a new sensor but it turned out it was wired wrong.

[nightrider93ex]

i finally put a litle bulb for the CEL......7 fast flashes over and over.....TPS is 7 isnt it??.....

[nightrider93ex]

i got the new tps on...vtec is kicking in now....but now i have a bouncy idle

[d112crzy]

Iacv

[nightrider93ex]

so i should just adjust it till the idle is about right?

[d112crzy]

that, or you could take it off and clean it.

[v4lu3s]

did you put the new TPS in and get it adjusted proplerly with a multimeter?

[nightrider93ex]

no..i put the tps on there....and adjusted the IACV and it went away for a while but then it came back.... ....NOT EVEN THAT.....stupid vtec is still fluttering!!.....

[d112crzy]

did you even put the tps in correctly? it has this little rotor that you gota line up in the back of the tb, then you gota adjust it to spec with a voltmeter.