stumped

[JDMjunkie]

okay so my ECU was throwing a code for the knock sensor, i thought maybe it would be a bad sensor so i changed it, now im getting a code for the knock sensor again, my gas mileage is soo shitty, i need help, can anyone help me?

[JDMjunkie]

anyone??

[cp[mike]]

use a multimeter and make sure there is a good connection between the sensor connector and the pin on the ECU...

[NAiL05]

As mike said make sure its plugged into the ECU properly and hooked up to the plug right.

[JDMjunkie]

could you tell me the pinout on the ecu for the sensor?

[Accord R33]

mabye you have knock...?

[JDMjunkie]

no i dont, ive listened to the engine and its not making a noise

[NAiL05]

Look in the swap faq...It will give you the complete pinout.. IF you hooked it wrong then yea that could be another reason.

[JDMjunkie]

okay well i checked the FAQ, i found out that its in the wrong pin on the connector, i have a question tho, the knock sensor isnt hooked up to the shock tower connector, it goes straight to the ecu, is that a problem?

[cp[mike]]

okay well i checked the FAQ, i found out that its in the wrong pin on the connector, i have a question tho, the knock sensor isnt hooked up to the shock tower connector, it goes straight to the ecu, is that a problem?

it would only be going thru the shock tower connector if it was wired in from the factory... with the swap, somebody had to add the wiring, and they ran it straight to the ECU. which is fine, unless you want to take the motor out.

[JDMjunkie]

it would only be going thru the shock tower connector if it was wired in from the factory... with the swap, somebody had to add the wiring, and they ran it straight to the ECU. which is fine, unless you want to take the motor out.

lol its arite, well thanks for the input, now its time to de-pin the knock sensor and put it in D3