So yesterday I installed a megan racing header and after I got it all back together i got a CEL. On the egay header I had before I had cut the wires on my O2 sensor and make it long enough to reach around front where it had the O2 sensor located. When I got the megan header I was like ok, back to the stock location. Then I got a CEL. I assumed it was from me cutting and splicing the wires. So today I went and got a new Bosch O2 Sensor and now I'm throwing this Code 41. I read the haynes manual but ti describes it like I'm some sort of an electrical engineer. Can someone tell me whats goin on? It runs right now, but its damn rough and nearly cuts off when it idles down.



The beginning of a new era............................
Comment