A/C Line (low)

[dean_harryman]

Some of you may have seen my last post on my a/c conversion.

Well I have some news, the jb weld DOES NOT hold.

so no one try that!

Now I need a low side ac line.... if anyone knows where I can get one, or if you have one laying around let me know!

Also, If anyone has a good Idea of fixing this pin sized hole, let me know.

I thought about removing the line and brazing it, and I thought of soldering it, and then covering it with a rubber hose and clamping it, but i would rather replace it.

I have called some new parts dealers, and no one carries the low side.

now i have to start looking used. MAN this sucks! it is too damn hot, and getting hotter!

well I am off to the store in my Honda powered oven.... get back to me soon... LOL

[bruno8747]

The low pressure line still has enough pressure to blow out any rubber hose. And there were 2 different types of compressor available for our cars, And the lines differ for each So you have to get the line that corresponds to your compressor.

[dean_harryman]

I guess I will have to check the compressor before I go to pick-a-part then

the low side should only have 45-50 psi.... but your right that would pop a rubber hose. What I was saying is I wanted to solder the line, then cover the soldered area with a hose and clamps just to be sure....

Thanks for the info about the compressor, I didn't know that!