Few Questions!!!!

[SuperTuner12010]

1st today for somereason my passenger window wont go up, driver side does but not my passenger and I have a coupe by the way.So could it be a fuse, relay or did the motor go out?

2nd I want to do a starter kill switch.Although I want to use my cruise switch becasue I dont have cruise control. I will be using this diagram
So for the wire that would go to a rocker switch how could I use the cruise swithc thanks....

[BustedLX]

If you want the car to only start when the cruise switch is depressed (engaged) you can not use that diagram.

You'll have to interupt the factory starter wire, put the starter end on pin 87 and the key end on pin 30. If the Cruise switch will be outputing a positive (+) voltage then connect it to pin 86, then connect pin 85 to ground. If the Cruise switch will output ground then connect it to pin 85 and connect pin 86 to pin 30 (key side).

If you choose to have the Cruise switch output positive then you must connect it's positive source to a switched ignition run lead, meaning a switched ignition that does NOT lose power when the starter is engaged, like the radio, A/C, etc. but that maintains it like the injectors, ecu, etc.

It could be either the switch or the motor that has taken a dive in your car, only thing you can do is take it apart and test it.

Hope this helped.

[SuperTuner12010]

That helps but im confused, can you go in a little deeper? I just want to know the easiest way to do this....I dont car how it uses the cruise swithc just as long as I have the switch working.Because most likely he light on the switch.Thanks

[SuperTuner12010]

Anyone?

[SuperTuner12010]

Bump

[BustedLX]

That helps but im confused, can you go in a little deeper? I just want to know the easiest way to do this....I dont car how it uses the cruise swithc just as long as I have the switch working.Because most likely he light on the switch.Thanks

You'll have to test the switch to see what it outputs or rewire the swtich so you can repurpose it to your need.

Do you have a multimeter?

[SuperTuner12010]

Yah I have one, how do I rewire it correctly?Thanks

[SuperTuner12010]

Bump

[BustedLX]

Pull the switch out of the dash and test it's leads, once you've determined which leads are supply and load you can cut them and reuse them for what ever you want.

Should be pretty easy, when I get home I'll pop my switch out of the dash and look at it. If I remember correctly it should be only a 3 wire switch.

[SuperTuner12010]

Its a 4 or 5 wire If I remember right....id check myself but im not to use to using a volt meter and how to use it.

[SuperTuner12010]

bump

[10thcb7]

BustedLX has tried to help so will i. Im not a wiring specialist by no mean but i know how systems work so take the door panel off carefully cut off the white plastic check to see if the plastic regulator that the motors wire guides its self with hasnt damaged it. Later

[SuperTuner12010]

Bump.....So does anyone know withc wire it is to use when doing a kill switch.The Cruise control switch to be exact