i just received an o2 sensor from a member here and it was from an LX model (sensor up on the manifold). now my car is also an LX, but when i went to plug in the o2 sensor plug-to-plug, it didn't want to go in. it seems like my harness end has 4 little plastic prongs behind each pin, and the sensor plug only has the female ends for the 4 pins, and not the plastic prongs. since it's from an LX a1 motor, shouldn't these be the same plug/sensor?
-
-
pics.... you probably left something in the connector itself from the old o2 or you plugged it in the wrong way.
The beginning of a new era............................
165 hp 149 ft. lb. torque sohc non vtec. then....
184 whp and 149 ft. lb. torque f20b stock now...... -
lmao i feel dumb now. went at it with needlenose pliers, and whaddya know, a piece of the old plug! thanksOriginally posted by jhondayaaj
Comment
-
That little white piece? That's happened to me a couple times before
on the stairs, she grabs my arm, says whats up,
where you been, is something wrong?
i try to just smile, and say everything’s fine.Comment
-
yes. and the rubber thing around it. it all looked so legit, then i pulled it out. you should have seen my faceOriginally posted by accordaffairComment
Comment