The first pipe had to be extended maybe 3-4 inches. To reach the connecting pipe lower. You can't see this as pipe #1 crosses behind the other 3. He used a slightly smaller diameter pipe to do this. Eventually I'm going to buy some matching pipe and correct this, just low on the list for now. Other than that it was just 5 hours of labor at the exhaust shop. My guy had to test fit and tact weld stuff then remove the header, and weld a little and let it cool. Repeat the process till done. He didn't want to warp the flange so it took quite a bit of time. Also I don't know if I have a picture of it but this leads into a Vibrant 18" or 24" resonator, which then leads to the cat back. I'm going to pull my 2.25" stainless steel MagnaFlow cat back off the sedan this weekend and get it swapped over. That will complete the exhaust for awhile. Eventually I'm going to buy the KTeller 3" stainless steel kit and add another resonator to it possibly.
Here in a few hours I'm going to find out about registration. Just waiting for the DMV in the courthouse to open. I work for the county so it's only a couple blocks away.
Here in a few hours I'm going to find out about registration. Just waiting for the DMV in the courthouse to open. I work for the county so it's only a couple blocks away.
Comment