SMseagren83 : 2006 Mitsubishi EVO IX-MR

[Father Time]

Your exhaust sounds pretty deep. Nice work so far.

[fatboy1185]

How's this cars all-wheel drive system break down? is it like 30% front, 70% rear?

[SMseagren83]

How's this cars all-wheel drive system break down? is it like 30% front, 70% rear?

this aint so Subi!!

its 50/50 and loves eating down on tires.

[fatboy1185]

50/50 nice.

[dohcb7]

yup 50/50, so wat are ur future mods for it?

[SMseagren83]

yup 50/50, so wat are ur future mods for it?

JDM EVO IX rear bumper
JDM EVO VII red tail lamps
JDP Engineering CF rally front lip
EDM Evolution IX trunk emblem
Beatrush undertray panel
Beatrush front engine roll stopper
Beatrush front strut bar
Beatrush manifold cover
Ralliart hood-vent panel
Tomei 65/70mm downpipe
Tomei O2 housing 65mm
Tomei duracon shift knob (short)
Tomei ARMS turbo *way later*
Whiteline 26mm front sway
Whiteline 24mm rear adj. sway
Whiteline roll center correction kit
TUNE
Some other little stuff...... :P[/B]

thats pretty much everything i currently plan on! i might add some cams.... but im undecided. only looking for 350-400whp.

[dohcb7]

JDM EVO IX rear bumper
JDM EVO VII red tail lamps
JDP Engineering CF rally front lip
EDM Evolution IX trunk emblem
Beatrush undertray panel
Beatrush front engine roll stopper
Beatrush front strut bar
Beatrush manifold cover
Ralliart hood-vent panel
Tomei 65/70mm downpipe
Tomei O2 housing 65mm
Tomei duracon shift knob (short)
Tomei ARMS turbo *way later*
Whiteline 26mm front sway
Whiteline 24mm rear adj. sway
Whiteline roll center correction kit
TUNE
Some other little stuff...... :P[/B]

thats pretty much everything i currently plan on! i might add some cams.... but im undecided. only looking for 350-400whp.

nice! with cams ull get there alot faster, my setup on my is:

denso 750cc
walbro 255
rmr upper ic pippes
ams lower ic pippe
hks 272 cams
3inch turbo back with an invidia canister
findza gears
hbx intercooler
fpgreen
ported muse manifold
ported invidia o2 housing
ported hotside
aem intake
and a tuned to 22psi

im also trying to get the jdm 9 rear but its hard for an ly evo, i already got the jdm 9 tails

[noobcake]

i fucking love evo's

your a bastard sean

[d112crzy]

going too low does not allow enough suspension travel, and thus worse handling...Especially if its a daily, I would want spring rates less than 350...

Not with modified top hats.

Anyways, can't wait to ride in it again once I get back. I want to go sideways in something other than my moms JDM van.

[SMseagren83]

Not with modified top hats.

Anyways, can't wait to ride in it again once I get back. I want to go sideways in something other than my moms JDM van.

You might as well wait for the sways and roll center kit to show up before you jump in.


MORE PICTARs!! just a couple minor add ons. vvv i hate pollen!! vvv


visors and settled drop.




this turbo inlet pipe was a bitch to replace!! almost 2hrs.... ugh.

[zack_odom]

Awwww. that turbo is cute.

[Father Time]

Pancakes.


Looking really nice Sean.

[SMseagren83]

Pancakes.


Looking really nice Sean.

yeah, it could prolly make some decent pancakes!! lol should try it when my new fin plate comes in.

i STILL need a new rear bumper....

STILL waiting for the sways to show up...sure is nice that the company notified me that they didnt have them in stock.

STILL needs to be sent out for window tint.


and i REALLY want some wheels. cant decide on 17x9 or 18x8.5. RE30s are what i really want, but RPF1s are so effin cheap.

i need a raise! damnit!

[Boost_Lee]

the ix turbo is actually pretty damn good. My buddy is pushin 30 on his with some 110octane

lookin great as with all ur cars

[SMseagren83]

the ix turbo is actually pretty damn good. My buddy is pushin 30 on his with some 110octane

lookin great as with all ur cars

very true! you can get plenty out of it... it will do just fine for a long while and esp @ the hp/tq levels im currently aiming for.

and THANKS for the kind words.