Speedo Problem

[Ds060510]

I have a 93 ex 4dr...and its been driving fine after i fixed it...now the spedometer falls all the way down then back up...never seen this before

[ish493]

i had that same problem and spent like 500 going to a machanic but finlay
got it to work by changing the vss ill see if i can find the thread ok.

I have a 93 ex 4dr...and its been driving fine after i fixed it...now the spedometer falls all the way down then back up...never seen this before

here it is hope it help cus it helped me lol http://www.cb7tuner.com/vbb/showthre...ght=VSS+issues

[Leung]

here you go.

http://techauto.awardspace.com/vss.html

[drew12000]

lboth these two are correct. theres also a diy on how to replace your vehicle speed sensor.

[dj_ender]

I have a 93 ex 4dr...and its been driving fine after i fixed it...now the spedometer falls all the way down then back up...never seen this before

The ignitor could also be the culprit.

[Ds060510]

thanks guys..lots of help on here VSS is on the tranny right?

[Ds060510]

how dumb of me...thanks for the link

[ish493]

Hopefully u get it fixed and running so u don't get speeding tickets.

[Krowned King]

im trying to figure out why mine dont work at all i have just been using my gps but it works lol..

[deevergote]

The ignitor could also be the culprit.

The ignitor would cause the tach to go nuts, not the speedo.

im trying to figure out why mine dont work at all i have just been using my gps but it works lol..

The problem is your VSS, your wiring, or your cluster itself. Start with the VSS, as that's most commonly the part that fails.

[dj_ender]

The ignitor would cause the tach to go nuts, not the speedo.




The problem is your VSS, your wiring, or your cluster itself. Start with the VSS, as that's most commonly the part that fails.

Yeah that was a bone head post, dunno what I was thinking. Op pull your cluster and look for damage like this:

[Ds060510]

what part of that picture is fried? or broken?

[deevergote]

The board looks burned to me right in the very center, to the right of the glare, on the other side of those two side-by-side solder points.

[dj_ender]

The board looks burned to me right in the very center, to the right of the glare, on the other side of those two side-by-side solder points.

Yes there are 4 discolored spots in a vertical line in the center of the pic. Those are causing the tach, speedo, and lights to not work.

[Ds060510]

oh ok ok..i see it now...mine seems to be fine...